Exhaust system replacement

The construction of the exhaust system is adapted to the different types of engines. In addition, the main exhaust pipe can have a different shape depending on the type of bodywork.…

Replace the exhaust manifold gasket

Engine 1.2

■ Remove the air filter.

■ Remove the six exhaust manifold mounting bolts. Push the manifold back and remove the gasket.

■ …

Idle speed control

A special compression-ignition engine tachometer is required to check and set the engine speed, working on the principle of a photocell.…

Setting the start of pressing

The injection pump start can be checked both with it installed, and the removed engine. A dial gauge with a suitable holder is required for checking, …

Solenoid valve replacement

The solenoid valve cuts off the fuel supply as soon as the engine is shut off.

■ Remove the power cable from the solenoid valve.

■ Unscrew the valve.

■ Screw in …

INJECTION PUMP (ENGINE 1,6 D)

Replacing the injectors

Damaged injectors can disrupt the combustion processes and, as a result, destroy the bushings. If "ringing."” engine, to …

Weber carburetor 32 TSP

■ Remove the air filter.

■ Pull off the fuel line and vacuum line,

■ Disconnect the throttle cable”.

■ Remove the crankcase ventilation hose.

■ …

Adjusting the start throttle

Weber carburetor 32 TSP

■ Remove the air filter.

■ Pull out the choke control completely”. The choke lever must then rest against …

Adjusting the "fast" idle

Pierburg 2E3 carburetor

■ Connect the tachometer.

■ Measure the CO concentration and idling speed of the engine warmed up to operating temperature (temperature …

Accelerator pump adjustment

Weber carburetor 32 TSP

■ Start the engine briefly and stop it

■ Turn the throttle lever as far as it will go. observe the fuel stream being fed through …