Replacing the valves of the lubrication system (engine 1,2)

Oil pump reduction valve replacement method.

The method of replacing the bypass valve is described below, which is located in the flange of the filter support …

Oil pump replacement and inspection (engines 1,3 and 1,6 D)

■ Remove the oil pan

■ Unscrew the toothed belt cover and remove the belt.

■ Remove from …

Oil pump replacement and inspection (engine 1,2)

■ Remove the oil pan

■ Remove the bolts securing the oil pump, using a polygon L-key.

■ Undo the fastening screws …

Change the oil filter

The oil filter must be replaced regularly, in accordance with the manufacturer's recommendations. It is possible to check, whether the oil filter is clogged as follows: when hot …

Replace the oil pan gasket (engines 1,3 and 1,6 D)

■ Drain the engine oil.

■ Screw the oil drain plug back in with a new seal (moment …

The engine is lubricated under pressure, produced by a gear pump, which one in the engine 1.2 it is housed in the crankcase and driven by the camshaft, a …

Camshaft replacement

■ Remove the engine head

■ Place the camshaft housing on two wooden blocks and remove the cover.

■ Remove the gear wheel fixing bolt …

Checking and adjusting the timing setting

■ Remove the air filter.

■ Remove the air filter.

■ Remove the camshaft housing cover.

■ Remove the clutch housing cover.

■ …

Replacing the toothed belt

■ Disconnect the battery from the vehicle's electrical system.

■ Remove the air filter.

■ Remove the cover from the clutch housing.

■ Remove the V-belt.

■ …

DISTRIBUTION (ENGINE 1,6 D)

Checking and adjusting the toothed belt tension

■ Loosen the alternator mounting and remove the V-belt.

■ Remove the upper and lower belt covers …