REAR WHEEL BRAKES – Brake drum replacement and repair
■ Loosen the rear wheel bolts. Secure the front wheels against rolling away. Zwolnić …
Replace the front brake caliper – Opel Kadett
The first thing to do is to disconnect the brake hose from the caliper. To do this, unscrew the hollow bolt and close the cable outlet with an appropriately selected plug.
Type clamp …
Caliper piston cover replacement – Opel Kadett
Caliper piston cover replacement
If it is found when installing new friction inserts, the caliper piston cover is damaged, it should be mentioned as follows.…
Replacing the friction inserts – Opel Kadett
FRONT WHEEL BRAKES
Replacing the friction inserts
■ Loosen the bolts of the front wheels, lift the front of the car and place it on the stands. Secure the rear wheels.
■ Remove the front wheels, …
Braking system – Opel Kadett
The front wheels are equipped with disc brakes with floating type single-piston calipers.The size of the front brakes is the same in all car models
They are located on the rear axle …
Dismantling the steering shaft assembly – Opel Kadett
Dismantling the steering shaft assembly
This operation can also be performed without removing the steering shaft assembly from the vehicle . Signal and wiper switch, lock cylinder and ankle …
POWER STEERING GEAR – Opel Kadett
POWER STEERING GEAR
Checking the oil level
■ Unscrew the cap from the reservoir and take it out together with the measuring cup attached to it.
■ Oil level in condition …
Replacing the ball joint of the steering rod – Opel Kadett
Replacing the ball joint of the steering rod
■ Remove the clasp and unscrew the castle nut
■ Using a suitable puller, disconnect the ball joint pin from the suspension strut arm…
Vibration damper replacement – Opel Kadett
Vibration damper replacement
To replace the steering gear vibration damper, it must first be unscrewed from the bracket, and then from the clamp.
The top clamp bolt should be used for this …
Adjusting the start of delivery of the VP44 pump
Adjusting the start of pressing
The beginning of pressing is recorded as a map of characteristics as a function of engine rotational speed and fuel dose as a measure of the engine load.. As correction factors …