The band brake mechanism consists of the following parts: a brake drum with an outer working surface, mounted on the gearbox main shaft …
Daily Archives: November 14, 2013
Drum brake mechanism
Braking mechanisms. The task of the braking mechanism is to create the braking force of the car on the basis of friction. In terms of their construction, the brake mechanisms are divided …
Proper braking
The actual braking time is the time from the moment the brakes are applied until the vehicle is stopped; the vehicle's movement is delayed during this period. You have to remember, …
Braking distance
Braking distance. The braking distance is the distance traveled by the vehicle from the moment the driver notices the obstacle until the moment the vehicle stops. Time, in which the vehicle is on the road …
The role of the brakes
The role of the brakes. The job of the brakes, used in any motor vehicle, is to reduce the driving speed, stopping the vehicle and immobilizing it when stationary. Every motor vehicle should be …
Adjusting the camber angles of the front wheels using the HPA device
Adjusting the camber angles of the front wheels using the HPA device. We control and, if necessary, equalize the pressure in the tires to the value 1,6 kG/cm2, - We raise the front …
Camber angles of the front wheels
Camber angles of the front wheels. The camber angles of the front wheels should be equal in each car. The permissible angular difference between both wheels on the car should not be …
Car maintenance and inspection
Car maintenance and inspection. Before commencing maintenance and inspection, the vehicle should be washed and cleaned. This is necessary to protect the lubrication points from being introduced into …
Health and safety rules when operating a vehicle
Health and safety rules when operating a vehicle. All service, maintenance and repair work, where the employee must be under the car, should take place at stands equipped with …
The principle of checking the camber angle of the front wheel
The principle of checking the camber angle of the front wheel. The check is made on a level surface with the front wheels in straight position. Appropriate sizes must be set …